XRAY 355111 XB808 10T Bevel Gear - Durable HUDY Spring Steel  [XR-355111]

XRAY 355111 XB808 Pinion Gear 10T
Price:
CAD$28.11
Brand:
XRAY
Model:
XR-355111
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Upgrade XB808 Differentials with XRAY 355111 10T Bevel Gear

The XRAY 355111 XB808 Pinion Gear 10T is a purpose made component that boosts the toughness of your RC drivetrain. Machined from HUDY Spring Steel, this bevel gear is produced with tight tolerances to deliver dependable service life. It fits the XB808 front and rear differentials and is intended to reduce wear during prolonged running.

Built for Endurance

This 10 tooth bevel is designed to withstand repeated stress. The HUDY Spring Steel construction provides elevated fatigue resistance and the heat treatment increases surface strength, helping the gear hold up under heavy use and stop premature failure.

Precise Tooth Geometry for Smooth Drive

Every XRAY 355111 gear is finished on specialised equipment to ensure each tooth meshes cleanly. That accurate tooth form lowers friction in the differential and helps maintain consistent power transfer, improving control and drivetrain efficiency.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will the 10T bevel fit both front and rear XB808 differentials?

This XRAY 355111 10T bevel is made for the XB808 series and is intended to fit the standard front and rear differential housings without modification.

What does HUDY Spring Steel bring to the gear?

HUDY Spring Steel offers high wear resistance and strength. Combined with heat treatment, it improves resistance to chipping and extends the part life under repeated loads.

Any setup tips after installation?

Check and set correct gear mesh, apply a light gear grease to the teeth, and run initial inspections after a few sessions to ensure the mesh is holding and there is no unusual wear.

Copyright © 2008-2025 rcjaz.ca All rights reserved