XRAY 353151 Rear Camber Link Ball Joint Set for XT8  [XR-353151]

XRAY 353151 Relief Rear Upper Outer Camber Link Ball Joint (2)
Price:
CAD$14.72
Brand:
XRAY
Model:
XR-353151
Condition:
Brand New
Write a review

Fine-Tune Suspension with XRAY 353151 Ball Joints

The XRAY 353151 Rear Camber Link Ball Joint is made to refine the suspension geometry on your XT8. These molded composite joints fit the outer ends of camber link turnbuckles and balance strength with the slight compliance needed for consistent handling. The pack contains two pieces for easy replacement or spare use.

High-Wear Composite Build

Built from a tough composite material, these ball joints resist abrasion and deformation under regular running. That durability helps keep your suspension consistent lap after lap.

Dial In Your XT8 Handling

These joints give precise control over camber settings so you can tune cornering balance and tyre contact patch for different surfaces. They are an essential small part for owners serious about setup work.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will these ball joints fit models other than the XT8?

They are produced for the XT8 outer camber link ends. Other models may share dimensions but fit is not guaranteed without checking the part measurements.

What comes in the package?

The package contains two rear camber link ball joints, enough to service one side or keep as spares.

Any tips for installation and setup?

Install on the outer turnbuckle ends, check freedom of movement, and inspect for play after a few runs. Replace in matched pairs for balanced handling.

Copyright © 2008-2025 rcjaz.ca All rights reserved