XRAY 352318 Steel Front Suspension Holder - Laser Cut Reinforcement  [XR-352318]

XRAY 352318 Steel Suspension Holder - Front - Laser Cut
Price:
CAD$13.88
Brand:
XRAY
Model:
XR-352318
Condition:
Brand New
Write a review

Precision-cut Steel Holder for Front Suspension

The XRAY 352318 Steel Suspension Holder is a zinc-coated, laser-cut component made for the front end of older XT Series RC cars. Its precise fabrication adds solid support to the suspension assembly, improving stability and extending service intervals under regular use.

Designed to Strengthen Older XT Series Setups

This holder is made to drop into the composite suspension holder found on earlier XT Series models. By reinforcing that joint it reduces wear on the original parts and helps retain correct geometry, making it a practical upgrade for maintaining classic RC chassis. The laser-cut profile gives a snug fit that keeps the assembly reliable during club runs and weekend driving.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this fit my older XT Series front suspension?

It is intended to fit the composite front suspension holder used on earlier XT Series models, but check your chassis layout for the same mounting points before fitting.

What is the plate made from and how does it resist corrosion?

The plate is zinc-coated steel which gives good strength and basic corrosion protection; regular cleaning and light oiling will extend its life.

Are special tools needed to install this holder?

Installation typically uses standard RC hand tools like hex drivers and a small spanner; follow the vehicle's assembly order and torque hardware to spec.

Copyright © 2008-2025 rcjaz.ca All rights reserved