XRAY 337310 Rear Lower Inner Pivot Pin Set NT1 Upgrade  [XR-337310]

XRAY 337310 Rear Lower Inner Pivot Pin (2)
Price:
CAD$16.45
Brand:
XRAY
Model:
XR-337310
Condition:
Brand New
Write a review

Rear Lower Inner Pivot Pins Built for Durability

Upgrade your XRAY NT1 with rear lower inner pivot pins made to resist wear and extend component life. These pins are hardened to cope with sustained race use while keeping rear geometry consistent.

Precision Fit for Competitive Driving

The XRAY 337310 pins are produced to fit the NT1 series precisely, delivering predictable handling during high speed sections and tight lines. The kit contains two precision pins intended as direct replacements or a durability upgrade.

The Advantage of Hardened Pins

Hardened pivot pins reduce deformation and surface wear under repeated load, helping maintain setup and reducing service intervals. They suit racers and regular club drivers looking for a reliable chassis pivot point.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will these fit older NT1 years or kit revisions?

These pins are made for NT1 specification pivot housings. Some older or modified NT1 variants may differ, so check your chassis pivot bore before ordering.

Do I need special tools to install them?

Installation is straightforward with basic RC tools such as needle-nose pliers or a drift and a light hammer. Use care to avoid damaging the bore when pressing pins in.

How often should I replace pivot pins in race use?

Replacement interval depends on track conditions and driving style. Hardened pins last longer than stock items, but inspect for play or surface wear regularly and replace when any looseness appears.

Copyright © 2008-2025 rcjaz.ca All rights reserved