XRAY 329700 Low-Profile 1/10 2WD Buggy Body  [XR-329700]

XRAY 329700 Body for 1/10 2WD Off-Road Buggy 0.75mm
Price:
CAD$66.60
Brand:
XRAY
Model:
XR-329700
Condition:
Brand New
Write a review

Precision aerodynamics for 1/10 2WD racing

The XRAY 329700 body is tailored to fit the XB2 chassis, delivering a snug fit and predictable handling across a range of track layouts. Its low-profile shape is focused on reducing drag while creating useful downforce at both front and rear for steadier cornering.

Side stability and controlled airflow

Careful sidewall shaping on the XRAY 329700 helps air move cleanly around the cockpit and flat sides, which reduces yaw and improves lateral grip. The roof incorporates two flow channels to feed consistent air over the shell and help keep the car balanced at speed.

Robust 0.75mm Lexan build

Made from premium 0.75mm Lexan, this body is built to resist impacts common in club and race settings while preserving the flex and weight RC drivers expect. The material choice gives a durable upgrade that stays serviceable lap after lap.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this shell fit other 1/10 2WD platforms?

The XRAY 329700 is optimised for the XB2, but it can fit other 1/10 2WD buggies that share similar wheelbase and body mount positions. Measure before trimming to ensure a good fit.

How should I paint this Lexan body?

Use polycarbonate-specific paints applied from the inside. Mask mounting holes and windows before spraying and allow full cure time to avoid runs and chipping.

Does the roof channel change handling?

Yes, the dual roof channels help stabilise high speed direction changes by smoothing airflow, which reduces lift and improves front to rear balance.

What trimming is needed for installation?

Trim to fit the XB2 mounting points and cut wheel arch openings to match tyre size. Test fit before final paint to ensure alignment with shock towers and wing mounts.

Copyright © 2008-2025 rcjaz.ca All rights reserved