XRAY 305433 Kevlar Front Drive Belt 3 x 501 mm Vintage T Series Replacement  [XR-305433]

Restore Older T Series Cars with the XRAY 305433 Kevlar Drive Belt

For hobbyists maintaining or restoring older XRAY T series models, the XRAY 305433 High-performance Kevlar Drive Belt is an essential component. Designed to fit the front section of your RC car, this belt measures 3 x 501 mm and is made from tough Kevlar fiber to resist stretch and wear. That construction helps deliver dependable performance during club runs and weekend maintenance sessions.

Kevlar Benefits Compared to Standard Belts

Kevlar belts resist elongation and handle repeated high-tension use better than ordinary rubber belts. They reduce the risk of sudden failure under load and hold tuning settings longer, which is useful for anyone pushing vintage T series cars at higher speeds or on rough layouts.

Fitment Advice and Simple Installation Steps

The XRAY 305433 belt is produced to match older T series specifications so it should slip into place without modification. During installation, check pulley alignment and even tension along the belt run to prevent uneven wear. Make visual inspections before each outing and replace the belt if you spot fraying or glazing.