XRAY 303455 4.9mm Composite Ball Joint Set for Anti-Roll Bars  [XR-303455]

XRAY 303455 Composite Anti-Roll Bar Ball Joint 4.9mm (4)
Price:
CAD$16.99
Brand:
XRAY
Model:
XR-303455
Condition:
Brand New
Write a review

Tune Handling with XRAY 4.9mm Composite Ball Joints

RC tuners looking for dependable adjustments will find the XRAY 303455 Composite Anti-Roll Bar Ball Joint useful. This set of four 4.9mm joints is molded from reinforced composite to give predictable wear characteristics while letting you dial in roll stiffness and height.

Features Overview for XRAY 303455

The XRAY 303455 kit is made to fit common 1/10 scale anti-roll linkages and to simplify setup changes. Key points to note are listed below.

  • Material: Molded composite for long service life
  • Size: 4.9mm diameter to suit standard anti-roll bar link ends
  • Adjustability: Built-in hole accepts an M3x4 setscrew for straightforward height adjustment
  • Quantity: Supplied as a set of 4 pieces for a complete linkage replacement
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will these ball joints fit my 1/10 touring car anti-roll bar?

They fit most 1/10 scale cars that use standard 4.9mm anti-roll bar link ends. Check your linkage inner diameter to confirm compatibility.

How do I set the ride height with the M3x4 screw?

Loosen the setscrew, position the joint to the desired height on the linkage rod, then tighten the M3x4 screw while holding alignment. Recheck under load after a short test run.

Are these ball joints durable for regular club racing?

Yes, molded composite material resists typical wear from road and track use, though inspect them regularly and replace when you notice play or cracking.

Copyright © 2008-2025 rcjaz.ca All rights reserved