Xenon Racing PPR64-37 64P/37T Precision Pinion Gear  [PPR64-37]

Xenon Racing Xenon Pinion Gear 64P/37T PPR64-37
Price:
CAD$12.44
Brand:
Xenon Racing
Model:
PPR64-37
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Precision Pinion for Serious RC Racers

The Xenon Racing PPR64-37 pinion gear is made to improve consistency and control in competitive RC drivetrains. With a 37T tooth count and 64P pitch, it provides accurate mesh and smooth rotation suited to race-focused setups.

Engineered for Consistent Power Transfer

Manufactured to tight tolerances, the Xenon Racing pinion helps distribute load evenly across the teeth to reduce wear and deliver predictable power delivery from the motor to the gearbox. Its profile supports efficient transfer for repeatable lap times.

Tuning Friendly for Track Performance

When you are dialing in gear ratios or swapping parts between sessions, the PPR64-37 is compatible with a variety of racing platforms and makes fine adjustments straightforward for drivers focused on handling and speed.

Will the Xenon Racing PPR64-37 fit my 64P spur gear?

If your setup uses a 64P spur and the correct shaft diameter, the PPR64-37 will mesh correctly. Always verify shaft size and set pinion height to achieve the recommended contact pattern.

How should I set mesh with the PPR64-37?

Use a thin strip of paper or a mesh gauge between pinion and spur, tighten the pinion until a slight drag is felt, then lock it in place. Recheck after a short run as new gears can settle.

Is there a recommended break-in for this pinion?

A short break-in at reduced power helps the teeth seat together. Inspect the mesh and fasteners after initial runs and retorque where necessary to maintain consistent engagement.

Copyright © 2008-2025 rcjaz.ca All rights reserved