TEAMPOWERS 64P Hard-Coated Pinion Gear 40T (TP-PG6440) - Motor Upgrade  [TP-PG6440]

TEAMPOWERS Hard-Coated 64P Pinion Gear , 40T (TP-PG6440)
Price:
CAD$7.58
Brand:
Team Powers
Model:
TP-PG6440
Condition:
Brand New
Write a review

Optimize Motor Output with TEAMPOWERS TP-PG6440

TEAMPOWERS 64P Hard-Coated Pinion Gear, 40T, is a practical replacement part for hobbyists who want stable, efficient gear engagement in their RC models. Built for accurate tooth profile and reduced wear, this pinion helps smooth motor response without extra complication.

Benefits of the Hard-Coated 64P Tooth Profile

Pinion choice directly affects torque delivery and top speed; the hard coating on this 64P unit helps resist abrasion and keeps mesh consistent under load. That improved durability translates into lower friction and longer service intervals between changes.

How Hobbyists Use the 40T Pinion

The 40T size fits a range of motor setups, making it useful for fine tuning gearing whether you are focused on club racing or general running. It installs cleanly into common motor shafts and lets you test different ratios with minimal fuss.

Will this fit my 540-sized motor shaft?

Measure your motor shaft diameter and spline count first; the TP-PG6440 uses a 64P pitch so check compatibility with your pinion bore and set screw position.

Is the hard coating serviceable or permanent?

The coating is a factory surface treatment designed to extend life and is not intended to be refinished at home, so plan for long term use rather than recoating.

Any setup tips for smooth mesh?

Set a small clearance between pinion and spur, ensure shafts are parallel, and run a light break-in lubricant during initial use to reduce noise and wear.

Copyright © 2008-2025 rcjaz.ca All rights reserved