TEAMPOWERS TP-PG6431 64P Hard-Coated 31T Pinion Gear  [TP-PG6431]

TEAMPOWERS Hard-Coated 64P Pinion Gear , 31T (TP-PG6431)
Price:
CAD$7.58
Brand:
Team Powers
Model:
TP-PG6431
Condition:
Brand New
Write a review

Fine-tune Motor Efficiency with TEAMPOWERS 64P Pinion

The TEAMPOWERS 64P hard-coated pinion with 31 teeth (TP-PG6431) is built for modelers wanting a dependable, precisely cut gear for electric motors. Its accurate tooth profile promotes consistent engagement and reliable performance across a range of setups.

Built for Long Service Life and Accurate Tooth Mesh

The hard-coating on this 64P pinion improves resistance to wear while preserving the tooth form under load. Tight manufacturing tolerances reduce unwanted play and slippage, delivering steady power transfer without frequent gear changes.

Reduced Friction for Cooler, Longer Runs

Lower friction is a key advantage of the TP-PG6431, helping motors run cooler and sustain output during extended sessions. That makes it suited to racers and hobbyists who demand consistent performance over time.

Which motors accept a 64P 31T pinion?

This 64P pinion fits motors designed for 64 pitch gears. Before fitting, check your motor shaft diameter and spline style to confirm compatibility.

Any tips for getting the gear mesh right?

Set a small, even gap between pinion and spur and lock the motor in place, then test by rotating the drive to verify smooth engagement. Use shims or adjust the motor mount as needed for correct mesh.

How should I maintain the hard-coated pinion?

Keep the gear free of grit and inspect teeth regularly for chips. Clean with a soft brush and avoid abrasive cleaners to preserve the hard-coating and tooth geometry.

Copyright © 2008-2025 rcjaz.ca All rights reserved