TEAMPOWERS TP-PG6430 Hard-Coated 64P 30T Pinion Gear - Track Ready  [TP-PG6430]

TEAMPOWERS Hard-Coated 64P Pinion Gear , 30T (TP-PG6430)
Price:
CAD$7.58
Brand:
Team Powers
Model:
TP-PG6430
Condition:
Brand New
Write a review

Upgrade your RC motor with TEAMPOWERS TP-PG6430 64P 30T

The TEAMPOWERS Hard-Coated 64P Pinion Gear with 30 teeth delivers a tough surface treatment to resist wear during frequent runs. Its precision cut helps reduce friction at the mesh, supporting more consistent motor behaviour and lower maintenance between races.

Built for Precision and Extended Service Life

Manufactured to tight tolerances, this pinion gear produces a reliable tooth profile for steady power transfer. The hard-coated finish reduces surface wear and helps maintain gear geometry, so you spend more time on the track and less time changing parts.

Fits Common 1/10 Electric Setups

This 64P 30T pinion is suitable for many 1/10 scale electric vehicles and works well in both on-road and off-road configurations. Its straightforward design makes it a practical swap when tuning gear ratios or replacing a worn pinion.

Is the TP-PG6430 strong enough for high rpm runs?

The hard-coated surface and accurate tooth profile make this pinion suitable for higher rpm use, provided your motor and spur are matched correctly and mesh is set up properly.

Will this pinion work with brushless setups?

Yes. The 64P 30T pinion is compatible with common brushed and brushless electric motors; check shaft diameter and spline fit before fitting.

Any tips for setting proper gear mesh?

Use a shim to set a small clearance, rotate the motor by hand to check for smooth engagement, and recheck after a short run to confirm the mesh remains stable.

Copyright © 2008-2025 rcjaz.ca All rights reserved