TEAMPOWERS TP-PG4828 48P Hard-Coated 28T Pinion Gear  [TP-PG4828]

TEAMPOWERS Hard-Coated 48P Pinion Gear , 28T (TP-PG4828)
Price:
CAD$7.58
Brand:
Team Powers
Model:
TP-PG4828
Condition:
Brand New
Write a review

TEAMPOWERS TP-PG4828 48P Pinion for Improved Motor Response

Fine-tune your RC rig with the TEAMPOWERS TP-PG4828 hard-coated 48P 28T pinion, built to provide stable, repeatable gearing. The precision tooth profile helps maintain consistent motor output for race days or practice sessions.

Long-Lasting, Low-Friction Finish

The hard-coat on this 48P pinion reduces wear while keeping friction down during high-speed runs. That durability suits racers and club drivers looking for reliable gear life across many runs.

Versatile Fit for 1/10 Scale Models

With a standard 48P pitch and 28 teeth, this pinion fits a wide range of 1/10 scale motor setups and supports smooth power transfer to the drivetrain.

What tools do I need to fit the pinion?

A pinion wrench or a small driver plus the appropriate hex key for your motor shaft set screw are normally enough. Fit the TEAMPOWERS TP-PG4828 to the motor and tighten to the motor makers recommended torque.

Is this pinion suitable for brushless motors?

Yes. The hard-coated 48P 28T pinion works with both brushed and brushless 1/10 scale motors provided the shaft diameter and spline match your motor.

Will the coating change mesh setup?

The coating is very thin and should not require different mesh than an uncoated pinion, but always verify mesh with a strip of paper and adjust as needed.

Copyright © 2008-2025 rcjaz.ca All rights reserved