TEAMPOWERS 48P Hard-Coated Pinion Gear 23T TP-PG4823 - Heavy Duty Upgrade  [TP-PG4823]

TEAMPOWERS Hard-Coated 48P Pinion Gear , 23T (TP-PG4823)
Price:
CAD$7.58
Brand:
Team Powers
Model:
TP-PG4823
Condition:
Brand New
Write a review

Performance-Focused Pinion for Motor Efficiency

The TEAMPOWERS 48P Hard-Coated Pinion Gear 23T TP-PG4823 is a straightforward upgrade for RC motors that need tougher, more consistent gearing. Its precise tooth profile helps reduce slop and promotes efficient power transfer from motor to drivetrain.

Robust Hard-Coated Finish

The hard-coated surface increases resistance to abrasion and surface fatigue, extending service life during regular running. This finish helps keep tooth profiles intact through repeated gear mesh cycles.

Tight Tolerances for Smooth Drive

Manufactured to close dimensional tolerances, the gear runs with low friction and stable engagement. That results in steadier acceleration and fewer drivetrain losses under load.

Broad Compatibility

This 23T 48P pinion is suitable for many 1/10 scale RC cars and trucks that accept 48P pinions, making it a versatile spare or performance swap for club racers and weekend builders.

Which vehicles typically use a 48P 23T pinion?

Most 1/10 scale onroad and offroad models that call for 48 pitch pinions can accept a 23T, provided the motor shaft and gearbox clearances match. Check your manual for shaft size and mesh limits.

Do I need special tools to fit the pinion?

Basic tools like a hex driver and a gear spanner are usually sufficient. Use feeler gauges or a shim method to set correct mesh and avoid binding.

How often should I inspect the gear?

Inspect after a few runs and then regularly if you race frequently. Look for chipped teeth, excessive wear on the coating, and any unusual noise in the drivetrain.

Copyright © 2008-2025 rcjaz.ca All rights reserved