Team Powers R-BLM-XXX100ACT-V5 Actinium V5 Sensored Brushless Motor 4.5T-25.5T  [TPR-BLM-XXX100ACT-V5]

Team Powers Actinium V5 4.5 T-10.5T, 13.5T, 17.5T, 21.5T,25.5T Turn Brushless Sensored Motor (TPR-BLM-XXX100ACT-V5)
Price:
CAD$208.94
Brand:
Team Powers
Model:
TPR-BLM-XXX100ACT-V5
Condition:
Brand New
Write a review

Race-Grade Performance with the Team Powers R-BLM-XXX100ACT-V5 Motor

For RC enthusiasts aiming to step up lap times, the Team Powers R-BLM-XXX100ACT-V5 delivers a precise, race-focused feel. Suited to 1:10 touring cars, buggies and mini cars, this motor balances efficiency and controllable power for competitive environments.

Built for Competitive Use

The R-BLM-XXX100ACT-V5 refines the Actinium V5 platform with improved sensor mounting and tighter assembly tolerances to give more accurate feedback to your ESC. Updated stator plate geometry and sealed fastenings stabilise the magnetic field and contribute to steady power output across long runs.

Tuneable Output Across Turns

Offered in options from 3.5T up to 25.5T, the R-BLM-XXX100ACT-V5 covers a wide tuning range so you can dial in top speed or low-end drive depending on track conditions. The rotor uses revised magnetic materials to sustain energy and reduce fade during extended heats.

Cooling Focused for Endurance

Thermal management is improved via a reworked motor shell that boosts convection and helps evacuate heat faster. The collector ring uses a specialised alloy to cut electrical resistance and aid heat dispersion so you can push harder without premature thermal loss.

Specifications

  • Motor Dimensions: 35.8mm x 52.2mm
  • Shaft Diameter: 3.17mm
  • Weight: ~150g
  • Recommended RC Model Car: 1:10 touring, Buggy, MINI Car
  • Available Turns: 3.5T to 25.5T

The Team Powers R-BLM-XXX100ACT-V5 is a practical upgrade for racers wanting consistent performance and efficient power delivery. Its construction suits both weekend club racing and serious practice sessions.

Choose a sensored-capable ESC with current capacity above your expected draw and a programming profile that supports sensor feedback for smooth throttle modulation.
Mounting is straightforward for experienced builders; ensure correct sensor alignment and motor height for pinion-meshing, and verify cooling clearance inside the body shell.
Regularly check bearings and sensor wires, keep vents clear of debris, and inspect mounting screws for tightness. Replace brushes are not applicable since this is a brushless unit.
It works well in 1:10 touring and buggy platforms where sensored control and consistent torque delivery improve corner exit and lap consistency.

Copyright © 2008-2025 rcjaz.ca All rights reserved