JAZRIDER JR-TA100-LB Light Blue Aluminum Main Drive Shaft for Tamiya TA01/DF01  [JR-TA100-LB]

Tamiya TA01/DF01 Aluminum Main Drive Shaft w/Joint (Light Blue) Set
Price:
CAD$10.74
Brand:
JAZRIDER
Model:
JR-TA100-LB
Condition:
Brand New
Available in warehouse
Write a review

Stiffen the Tamiya TA01/DF01 drivetrain with an aluminium main shaft

For builders wanting a reliable upgrade to Tamiya TA01 or DF01 cars, the JAZRIDER Aluminum Main Drive Shaft with Joint JR-TA100-LB replaces the factory plastic shaft to give a firmer connection between front and rear gearboxes. It is a practical swap for improved drivetrain response and reduced flex.

Why aluminium helps your setup

Aluminium drive shafts deliver higher strength at modest weight, giving hobbyists enhanced durability without a big mass penalty. The light blue anodized finish offers corrosion resistance and a tidy appearance that stands up to frequent running.

Fitting advice for smooth operation

Fitting the JAZRIDER shaft is straightforward: remove the stock plastic unit and install the aluminium part. Make sure joint fastenings are secure and free of binding. Proper installation helps reduce drivetrain lash and can improve power transfer efficiency.

Will this shaft fit both TA01 and DF01 gearboxes?

Yes. The JAZRIDER JR-TA100-LB is made to suit both Tamiya TA01 and DF01 layouts and installs in place of the plastic drive shaft.

How should I maintain the aluminium shaft?

Inspect the joints and splines regularly for wear, keep fasteners tight, and apply light grease to splines if recommended by your setup routine to prevent corrosion and noise.

Is this shaft suitable for higher power motors?

The aluminium shaft improves robustness over plastic, but if you run very high torque brushless systems consider inspecting drivetrain parts frequently and pairing with hardened pinions or reinforced dogbones where needed.

Copyright © 2008-2025 rcjaz.ca All rights reserved