JAZRIDER JR-TA103-GU Gun Metal Aluminum Front Gearbox Bottom for Tamiya TA01/TA02/DF01  [JR-TA103-GU]

Tamiya TA01 / TA02 / DF01 Aluminum Front Gear Box (Bottom)(Gun Metal)
Price:
CAD$12.64
Brand:
JAZRIDER
Model:
JR-TA103-GU
Condition:
Brand New
Available in warehouse
2 Reviews
Write a review

Practical JAZRIDER Aluminum Upgrade for Tamiya Chassis

The JAZRIDER Aluminum Front Gear Box (Bottom) in gun metal offers a robust replacement for the factory plastic unit on Tamiya TA01, TA02, and DF01 cars. This aluminium component provides a tougher contact surface and reduces wear on the original gearbox, making it a sensible upgrade for hobbyists who run their models frequently.

Fitment and Typical Use

This gearbox bottom is made to fit Tamiya TA01, TA02, and DF01 frames without complex modification. The aluminium construction adds rigidity and helps disperse heat better than plastic during extended sessions, which can aid component life under heavier use.

Fitting Advice

When fitting the JAZRIDER Aluminum Front Gear Box, tighten all screws to the correct torque and check gear mesh and bearing alignment before first run. Confirm clearances with adjacent parts to avoid binding and recheck after a short test run.

 

Product Reviews
2 Reviews
rating
This shop never failed to impress me.You can be assured of fast and quality service every single time.
rating
It's my first time ordering from overseas and JAZRIDER did a wonderful job.They were very helpful and their service was quick.Before I know it,my order has already arrived.I am very pleased with the result and I highly recommend this shop.Definitely b

Will this gearbox fit other Tamiya models?

This part is designed specifically for TA01, TA02, and DF01 layouts. Other Tamiya models may need modifications to accept this gearbox bottom.

What basic tools should I prepare?

A set of precision screwdrivers and small hex drivers is usually enough. Use the correct driver sizes to avoid stripping fasteners.

How should I maintain the aluminium gearbox?

Inspect mounting screws after the first few runs, keep gear teeth clean, and apply a light lubricant where appropriate to bearings and gears. Aluminium resists impact better than plastic but still benefits from routine checks.

Copyright © 2008-2025 rcjaz.ca All rights reserved