Tamiya M-07 Gun Metal Front C Hub - JAZRIDER JR-M703-GU Steering Upgrade  [JR-M703-GU]

Tamiya M-07 Aluminum Front C-Hub (Gun Metal)
Price:
CAD$12.23CAD$14.39
Brand:
JAZRIDER
Model:
JR-M703-GU
Condition:
Brand New
Available in warehouse
Write a review

Steadier Steering with the JAZRIDER Aluminum C-Hub

This JAZRIDER Tamiya M-07 Aluminum Front C-Hub in Gun Metal is built to give your M-07 a firmer, more repeatable steering feel. It fits the Tamiya M-07 chassis and is aimed at reducing play compared to the stock plastic piece.

Solid Construction for M-07 Chassis Use

Designed for practical durability, this aluminum C-hub provides greater resistance to wear than the factory plastic part. That added strength helps keep alignment consistent under load.

Benefits of Aluminum over Factory Plastic

Aluminum C-hubs flex less during aggressive driving, which helps maintain predictable steering behavior. That benefit is useful whether you are running club races or just pushing the car hard at the track.

Fitment and Basic Installation Advice

Fitting this C-hub is a straightforward swap. Tighten screws to the recommended torque, verify steering geometry after installation, and inspect fasteners after the first few runs to ensure everything stays secure.

Will this fit modified M-07 builds with different steering knuckles?

This C-hub is made for the standard Tamiya M-07 geometry. If your build uses nonstandard knuckles or custom offsets you should check clearances before installing.

Do I need special hardware to install the JR-M703-GU?

The C-hub uses common RC screws and hex fasteners. Keep the original mounting hardware unless damaged, and use thread locker only where you normally would.

How should I maintain an aluminum C-hub?

Inspect for play at the hinge points, clean grit from pivot areas, and recheck screw torque periodically. Aluminum benefits from routine checks to prevent wear on mating parts.

Copyright © 2008-2025 rcjaz.ca All rights reserved