3Racing BS-M06PRO/V1 Precision Ball Bearing Set for Tamiya M05  [BS-M06PRO/V1]

Tamiya M05 Ball Bearing Set - 3RACING BS-M06PRO/V1
Price:
CAD$18.80
Brand:
3Racing
Model:
BS-M06PRO/V1
Condition:
Brand New
Write a review

Upgrade Your Tamiya M05 Steering and Drivetrain

If you want cleaner roll and reduced drivetrain drag on a Tamiya M05, the 3Racing BS-M06PRO/V1 ball bearing set is a direct upgrade from standard bushings. These precision bearings cut friction so moving parts turn with less resistance, helping acceleration and consistency across laps. Built to last, they suit racers who run frequent sessions and want dependable results.

Benefits of Switching to Ball Bearings

Bushings work, but they can generate extra friction and wear under load. Fitting ball bearings lowers mechanical loss and keeps rotating assemblies tracking truer for longer. The 3Racing BS-M06PRO/V1 is made to fit the M05 platform for straightforward installation and trouble free integration.

Fitment and Care Advice

Before fitting the 3Racing bearing set, clean shaft ends and housings to remove grit. Apply a light bearing oil to each race to minimise wear and keep performance steady. With basic upkeep, this swap offers noticeable handling and speed improvements for club racers and hobbyists.

Will these bearings work in a converted M05 with aftermarket axles?

They are sized for stock M05 locations. If your conversion keeps stock axle diameters and housings the 3Racing BS-M06PRO/V1 should fit, otherwise verify axle and bore sizes before installing.

How often should I relubricate the bearings?

For regular club use, check and lightly oil bearings every few sessions or whenever you notice increased drag. For dusty or wet running, service them more frequently.

Do I need special tools to fit the bearings?

Basic hand tools and a careful press or driver are usually enough. Use gentle, even pressure and avoid hammering directly on bearing races to prevent damage.

Copyright © 2008-2025 rcjaz.ca All rights reserved