Tamiya 94954 JR HG Carbon Rear Roller Stay 1.5mm J-Cup 2013 Edition  [94954]

Tamiya 94954 - JR HG Carbon Multi Roller Stay - Rear 1.5mm (J-Cup 2013)
Price:
CAD$20.85
Brand:
Tamiya
Model:
94954
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Tamiya 94954 JR HG Carbon rear roller stay overview

The Tamiya 94954 JR HG Carbon Multi Roller Stay is a purpose-built part for Mini 4WD racers looking to refine rear-end handling. This 1.5mm carbon plate debuted with the Japan Cup 2013 and is shaped to accept multiple roller positions, letting racers tune cornering response and contact points to suit different tracks.

Made from stiff carbon material, the stay helps cut weight while keeping strength where it matters. The kit includes the basic washers and screws needed for fitment, and the array of pre-drilled holes lets hobbyists try different roller setups to balance speed and stability on race day.

Will this fit my Mini 4WD chassis layout

The Tamiya 94954 is compatible with many Mini 4WD rear assemblies, but chassis layouts vary. Compare mounting points on your car before fitting or plan small adjustments to screw positions.

How hard is it to install for a weekend racer

Installation is straightforward for anyone with basic RC tools. Use the supplied screws and washers, and test roller positions with a trial run to fine tune alignment.

What maintenance should I expect with a carbon stay

Inspect mounting screws and roller bushings regularly for loosening or wear. Clean carbon surfaces of grit to avoid abrasion and re-tighten hardware after a few runs.

Copyright © 2008-2025 rcjaz.ca All rights reserved