Tamiya DT-03 Red Anodized C Hub Upgrade JAZRIDER JR-DT304-RD  [JR-DT304-RD]

Tamiya DT-03 Aluminum C Hub (Red)
Price:
CAD$14.39
Brand:
JAZRIDER
Model:
JR-DT304-RD
Condition:
Brand New
Available in warehouse
Write a review

Solid red aluminum C hubs built for the DT-03

The JAZRIDER aluminum C hub in red is a practical, long-lasting upgrade for the Tamiya DT-03. These hubs replace the factory plastic C hubs to reduce flex and improve steering precision while absorbing the wear from frequent use.

Advantages of metal C hubs

Moving from plastic to aluminum delivers stronger contact points and reduced deformation under load. The red anodized finish also resists corrosion and keeps the hubs looking sharp after many sessions.

Fitting advice

Installation requires only basic tools and a careful hand. Tighten fasteners to factory torque to avoid binding. After fitting, check steering travel and toe settings to confirm the upgrade sits correctly. The red finish adds a clear visual upgrade to your build.

Will JAZRIDER JR-DT304-RD fit any DT-03 variant?

These hubs are made for the DT-03 platform. Some DT-03 variants may need minor shimming or different wheel hexes to match wheel offset, so check measurements before install.

What tools do I need to install them?

Basic hand tools are enough: hex drivers for the hub screws, a small socket or nut driver for wheel nuts, and a torque feel to avoid over tightening.

How should I maintain the red finish?

Wipe with a damp cloth after dusty runs and avoid harsh solvents. Check hardware for loosening and re-torque periodically to protect the anodizing.

Copyright © 2008-2025 rcjaz.ca All rights reserved