Tamiya 22068 BB-01 63mm Carbon Dogbone Shafts - 2 Pack Spare Parts  [22068]

Tamiya 22068 - BB-01 Dogbone Shafts/Swing Shafts 63mm (2Pcs) OP-2068
Price:
CAD$18.52
Brand:
Tamiya
Model:
22068
GTIN:
4950344220687
Condition:
Brand New
Available in warehouse
1 Reviews
Write a review

Sturdy drivetrain parts for BB-01 platforms

The Tamiya 22068 - BB-01 Dogbone Shafts are built to strengthen your RC car's drivetrain. Made from carbon tool steel and sized at 63mm, these dogbones offer a stronger alternative to stock parts to help reduce breakage during off-road runs.

Benefits of carbon tool steel dogbones

Upgrading to carbon tool steel dogbone shafts brings improved wear resistance and greater impact tolerance. Hobbyists running rough trails or frequent bashing will notice longer service life compared with standard shafts.

Fitment and straightforward swap

These 63mm dogbones are made for the BB-01 chassis and install with common hand tools. They are intended as direct replacements so you can swap them in quickly and get back on the track.

 

Product Reviews
1 Reviews
rating
Excellent service and communication for my large order, package arrived just 3 days later from 7347kms away speedy delivery 👍
They are designed for BB-01 chassis variants that use 63mm dogbones. Confirm your current shaft length before ordering to ensure a correct match.
Carbon tool steel offers higher strength and better wear resistance than typical plated or mild steel stock dogbones, so you should see fewer failures under heavy use.
No special tools are required. Basic hex drivers and pliers used for routine maintenance are sufficient to remove the old shafts and fit these replacements.
They are ideal for off-road and mixed-surface driving where the drivetrain sees impacts and abrasive wear. For light on-road use stock parts may be adequate.

Copyright © 2008-2025 rcjaz.ca All rights reserved