Tamiya 54845 3x50mm Aluminum Turnbuckle Shaft OP-1845 - precision lightweight tuning part  [54845]

Fine tune handling with the Tamiya 54845 3x50mm aluminum shaft

If you want tighter setup control, the Tamiya 54845 - 3x50mm Aluminum Turnbuckle Shaft swaps in for standard threaded rods to cut weight and give smoother adjustment during chassis tuning.

Benefits of aluminum hardware

Aluminum parts like this turnbuckle shaft are favoured for a good strength to weight trade off. At approximately 1.1 grams, it trims unsprung mass and can make small but useful gains in handling without sacrificing service life.

Versatile 3x50mm sizing for on-car setup

The 3x50mm length works across many tuning roles. Use it to dial in camber or toe with fine increments, helping you match the car's balance to tyre choice and track surface.

Hard-wearing blue anodised finish

The blue anodised coating gives a neat visual upgrade while adding a corrosion-resistant layer, helping the piece stay looking and working well despite regular use.