Tamiya 54062 48 Pitch Pinion Gear Set 13T, 14T, 15T OP-1062 - Precision Tuning Pack [54062]

Tamiya 54062 - 48 Pitch Pinion 13T, 14T, 15T OP-1062

Price:

CAD$18.34

Brand:

Tamiya

Model:

54062

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Dial in gear ratios with Tamiya pinion options

If you want tighter control over gearing for racing or club practice, Tamiya presents 48 Pitch Pinion Gears in 13T, 14T and 15T sizes. These pinions make it easier to fine tune drive characteristics on TRF501X and DB-01 chassis.

Greater setup accuracy and adaptability

The 13T, 14T and 15T pinions give small but meaningful steps in ratio so you can match gearing to track grip and driving style, helping balance acceleration and top speed.

What the kit contains

Pinion Gears: 13T, 14T, 15T
3x3mm Grub Screws: 3 pieces
1.5mm Hex Wrench: 1 piece

Example gear ratios for common chassis

Use these pinions to reach the following ratios depending on your spur gear choice and chassis:

TRF501X Chassis:

13T: 16.62:1 with 96T Spur Gear
14T: 15.43:1 with 96T Spur Gear
15T: 14.40:1 with 96T Spur Gear

DB-01 Chassis:

13T: 14.39:1 with 91T Spur Gear
14T: 13.36:1 with 91T Spur Gear
15T: 12.47:1 with 91T Spur Gear

Will these pinions fit other Tamiya models with 48 pitch gears?

They are designed for TRF501X and DB-01 gearlines but can fit other 48 pitch setups that use the same motor shaft dimensions; always verify shaft diameter and mounting style before fitting.

How should I install the pinion gear securely?

Position the pinion on the motor shaft, align it with the spur gear, then tighten the 3x3mm grub screw using the supplied 1.5mm hex wrench. Check mesh and recheck after a short run.

Which pinion size suits tight technical tracks?

Smaller pinions like 13T lower top speed and increase torque, which is useful for slow, technical circuits where acceleration and controllability matter more than outright top end.