Tamiya 54005 Nitrage 5.2 OP-1005 5mm Aluminum Rear Shock Tower  [54005]

Tamiya 54005 - Nitrage 5.2 Precision Aluminum Rear Shock Tower OP-1005
Price:
CAD$47.93
Brand:
Tamiya
Model:
54005
Condition:
Brand New
Write a review

Precision Rear Shock Tower for Tamiya 54005 Nitrage 5.2

The Tamiya 54005 - Nitrage 5.2 Precision Aluminum Rear Shock Tower is a direct-fit upgrade made from 5mm thick aluminum to give your buggy firmer suspension mounting. The added attachment holes provide more options for shock and upper arm positioning, helping keep dampers and arms secured under load.

Setup and Handling Benefits

Road and track tuners will value the extra hole positions for dialing in roll center and shock geometry. Careful adjustment using this tower can improve corner stability and straight-line control without changing other major components.

Fitment and Compatibility

This tower is intended for the Tamiya Nitrage 5.2 and is not compatible with the TNX 5.2R model. Confirm chassis compatibility before fitting to avoid modification or rework.

Will this fit the stock Nitrage 5.2 chassis without trimming?

Yes, the part is designed to replace the stock rear shock tower on the Nitrage 5.2 and should install without cutting. Check fastener positions match your existing hardware.

How does the aluminum tower change suspension feel?

Aluminum adds stiffness to the rear end, which stabilizes suspension pick up and reduces flex when landing or cornering, so handling feels more consistent.

Any special hardware needed to fit this tower?

It uses the same mounting points as the original tower in most builds, so standard screws and spacers are usually sufficient. Keep original parts for reference during installation.

Copyright © 2008-2025 rcjaz.ca All rights reserved