Tamiya 53830 - TNS Stainless Suspension Shaft Upgrade for TNS Chassis  [53830]

Tamiya 53830 - TNS Suspension Shaft OP-830
Price:
CAD$11.21
Brand:
Tamiya
Model:
53830
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Rugged Stainless Suspension Shaft for TNS Chassis

The Tamiya 53830 - TNS Stainless Suspension Shaft adds durable stainless steel construction to your RC setup to boost longevity and steering consistency. Built from corrosion-resistant stainless material, the shaft helps maintain smooth control and predictable handling across mixed surfaces. E-ring connectors fitted on both ends lock the shaft into the chassis for a reliable installation during maintenance or part swaps.

Compatible Models and Typical Use

This shaft is intended for use with Tamiya TNS chassis cars and is compatible with the TG10-Mk.1 when used alongside part number 53430. Its simple, robust design suits hobbyists seeking a practical replacement or a minor performance improvement.

Will the shaft fit other RC makes or models?

The shaft is made for TNS chassis cars and for TG10-Mk.1 with part 53430. It might fit other cars that share the same mounting spacing, but you should check dimensions before swapping parts.

How do I install the E-ring connectors safely?

Use a small pair of E-ring pliers or thin needle-nose pliers to position each E-ring into the shaft groove. Make sure the ring seats fully so the shaft cannot slide out under load.

Is this a common service part for maintenance?

Yes, many hobbyists keep spare suspension shafts on hand. The stainless version resists wear and corrosion, making it a sensible swap during routine rebuilds or after heavy running.

Copyright © 2008-2025 rcjaz.ca All rights reserved