Tamiya 53639 - 6mm Red Aluminum Ball Nut Set Anodized Red Upgrade  [53639]

Tamiya 53639 - Aluminum Ball Nut 6mm Red OP-639
Price:
CAD$12.20
Brand:
Tamiya
Model:
53639
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Secure Fit with Tamiya 6mm Red Ball Nuts

Upgrade your RC with high-grade 6mm red aluminum ball nuts from Tamiya, made to suit TB Evolution I, II, TGR, and TG10R chassis. The anodized finish resists wear while adding a clean, red accent to suspension and steering hardware.

Built for Lasting Use

The Tamiya 53639 ball nut set uses anodized aluminum for strength and reduced corrosion, helping maintain tight, dependable joints in race and hobby use. These parts are a sensible maintenance choice for drivers wanting consistent control.

Easy to Fit and Service

These nuts install using standard assembly steps in your vehicle manual and work with common ball studs and linkages. Proper installation ensures secure connections and improved feedback from steering and suspension linkages.

They are sized for 6mm ball studs and will fit most standard 6mm setups, but check stud diameter and thread compatibility before fitting to non-Tamiya parts.
The set is supplied with ten 6mm aluminum ball nuts, enough to replace multiple pivot points or to keep spares on hand.
Avoid aggressive cleaners and grit; wipe with a soft cloth after runs and inspect regularly for loose hardware to keep the anodized surface in good condition.

Copyright © 2008-2025 rcjaz.ca All rights reserved