Tamiya 51437 Urethane Front Bumper for RC M06 Chassis SP-1437  [51437]

Tamiya 51437 - RC M06 Urethane Bumper SP-1437
Price:
CAD$4.21
Brand:
Tamiya
Model:
51437
Condition:
Brand New
Write a review

Front end protection tailored for the M06 chassis

The Tamiya 51437 urethane bumper adds targeted protection to the front of your M06 PRO chassis. Made to take the sting out of light impacts, this part helps preserve bodywork and steering components during regular club runs.

Fitment and practical compatibility

Engineered for the M06 platform, the urethane material balances resilience and flex to reduce damage from knocks. Installation aligns with the M06 factory mounting points so no custom drilling is needed for typical setups.

Simple fitting steps

Fitting the Tamiya 51437 urethane bumper is a straightforward job that does not require special tools. Line it up with the existing mounts on the M06 chassis and fasten it securely to restore front-end impact protection.

Will this bumper fit other M06 based conversions?

This bumper is made for the M06 geometry; some M06 conversions will accept it without mods, but highly altered setups may need minor adjustment to mounting points.

How often should I check the bumper for wear?

Inspect the urethane after a few sessions and after any significant impact. Look for deep cuts or compression that could reduce its protective effect and replace if needed.

Does the bumper affect handling or weight balance?

The bumper adds minimal weight to the nose and is unlikely to change handling noticeably. It is primarily for impact absorption rather than performance tuning.

Copyright © 2008-2025 rcjaz.ca All rights reserved