Tamiya 41050 Aluminum Rear Exhaust Manifold .12/.15  [41050]

Optimize Exhaust Routing with Tamiya 41050

The Tamiya 41050 engine manifold gives RC builders a tidy way to redirect exhaust on .12 and .15 rear-facing engines, moving the muffler toward the vehicle front to aid smoother exhaust flow and more consistent throttle response.

Lightweight Aluminum Construction

Machined from quality aluminum, the Tamiya 41050 keeps added mass to a minimum while providing rigid support for the muffler mounting, helping preserve the car's handling balance.

Complete Fitting Kit Included

The kit contains everything needed for installation: one exhaust manifold, three nylon zip ties, two 3x30mm cap screws, two 3mm flanged nuts, two 3mm spring washers, a clear silicon muffler joint, FS-12 and FS-15 muffler gaskets, and an instruction sheet to guide the fitment.

Fitment Notes and Checks

Built for rear-facing side exhaust setups, this manifold requires that your engine and chassis have clearance for the forward-directed muffler. Double check engine orientation and muffler alignment before fitting.