Serpent 401624 Rear Wishbone Lightweight V2 XH Set - High Grip Racing  [SER401624]

Serpent SER401624 Wishbone Rear Lightweight V2 XH (2)
Price:
CAD$19.25
Brand:
Serpent
Model:
SER401624
Condition:
Brand New
Write a review

Refine Cornering with Serpent 401624 Lightweight Rear Wishbones

RC racers seeking sharper control will appreciate the Serpent 401624 Rear Wishbone Lightweight V2 XH set. Built for asphalt and carpet, these wishbones use a super-hard material to deliver longer life and crisper handling on high grip tracks.

Built for Strength and Track Stability

The Serpent 401624 components are made to resist wear while keeping your rear end steady through fast sweeps. The stiff, lightweight design improves predictability during high speed cornering without adding unnecessary mass.

Reliable Performance on High Grip Surfaces

These wishbones work well in warm track conditions where traction is strong. On both asphalt and carpet circuits the Serpent 401624 helps maintain consistent handling lap after lap.

Which Serpent chassis are compatible with these wishbones?

They are compatible with most current Serpent touring car chassis that accept the V2 XH rear wishbone design, but check your chassis parts list for mounting points and offsets.

Will they change my rear toe and handling?

The stiffer material reduces flex, which can tighten rear response and make the car feel more precise. Small setup tweaks to toe and camber may be needed to balance turn-in.

Any tips for fitting and break-in?

Use recommended fasteners and avoid over-tightening. Run a few gentle laps first to confirm alignment, then progressively increase pace to seat parts and check wear.

Copyright © 2008-2025 rcjaz.ca All rights reserved