Serpent SER401793 Aluminium Topdeck Holder Front and Rear for Project 4X PRO  [SER401793]

Serpent SER401793 Topdeck holder horizontal Front/Rear Aluminium 3X PRO
Price:
CAD$72.63
Brand:
Serpent
Model:
SER401793
Condition:
Brand New
Write a review

Chassis Reinforcement for the Serpent 4X PRO

The Serpent SER401793 Topdeck Holder is a precisely machined aluminium part made to strengthen the Project 4X PRO EP chassis. It bolsters structural integrity so the front and rear of the car remain securely fastened under race conditions.

Long Lasting Aluminium Design

Made from hard-wearing aluminium, this topdeck holder resists wear better than plastic pieces while keeping mass low to preserve handling and acceleration on track.

Designed to Fit Project 4X PRO

This component is matched to the Serpent Project 4X PRO EP (SER400032) family for a clean fit that integrates with the 4X PRO layout and improves chassis balance and predictability.

Fitment and Care Advice

When fitting the Serpent SER401793 Topdeck Holder, tighten screws progressively and check for even alignment. Periodic inspection and light maintenance will keep the part performing over many sessions.

Will this topdeck holder fit older 4X variants?

This SER401793 is built for the Project 4X PRO EP geometry and may not align correctly with older 4X variants without modification.

Do I need special tools to install it?

Standard RC hex drivers and a torque feel are sufficient; use even torque and avoid overtightening to prevent thread damage.

How often should I check the topdeck holder?

Inspect fasteners after each hard session and during routine maintenance to ensure alignment and to spot any signs of wear early.

Copyright © 2008-2025 rcjaz.ca All rights reserved