Serpent SER904177 22T Pinion Gear Replacement for Viper 988E  [SER904177]

Serpent SER904177 Pinion 22T 988E
Price:
CAD$22.02
Brand:
Serpent
Model:
SER904177
Condition:
Brand New
Write a review

Fine Tune the Viper 988E with a Serpent 22T Pinion

The Serpent SER904177 22T pinion is a precision component made for the Serpent Viper 988E EP. This 22-tooth pinion helps deliver smooth, reliable power transfer so your drivetrain stays efficient during spirited driving and track sessions.

Fit and Typical Use

Made to suit the Viper 988E EP, this pinion offers a precise fit that preserves gearbox alignment. Whether you are trimming gearing for circuit racing or weekend bashing, the SER904177 keeps drive response consistent across different track surfaces.

Practical Installation Tips

Fitting the Serpent 22T pinion is straightforward when the motor mount is correctly aligned. Make sure the pinion is secured tightly with the correct fastener and check gear mesh after a short test run. Inspect teeth for wear periodically to avoid unexpected failures.

Can I use this pinion on other Serpent models?

The SER904177 is engineered for the Viper 988E EP and offers best results there. For other models check shaft diameter and tooth pitch before fitting.

How do I tell when the pinion needs replacing?

Inspect the gear teeth for chipping, rounding or excessive play. If you notice noise, slipping or visible wear, replace the pinion to protect the spur gear and motor.

Any tips for setting correct gear mesh?

Use a thin shim or a sheet of paper to set a slight clearance between pinion and spur, then tighten the mount and recheck after a short run. Proper mesh reduces noise and prolongs gear life.

Copyright © 2008-2025 rcjaz.ca All rights reserved