Serpent SER904176 21T Pinion Gear for Viper 988E  [SER904176]

Serpent SER904176 Pinion 21T 988E
Price:
CAD$21.15
Brand:
Serpent
Model:
SER904176
Condition:
Brand New
Write a review

Tune Your Viper 988E with the 21T Pinion

The Serpent SER904176 21T pinion is a key service part for Viper 988E owners who want reliable tooth engagement and smooth power transfer. It is engineered to align with the Viper series drive layout for straightforward replacement and dependable operation.

Precision Fit for Consistent Drive

This 21T pinion delivers consistent meshing under load, giving predictable throttle response for electric Viper 988E setups. Its design supports routine running and maintenance without compromise to gear alignment.

Simple Fitment and Setup

The pinion is matched to the Viper 988E for correct fit and easy installation. When replacing it, check gear mesh and fasten securely to avoid slippage and premature wear.

Can I fit this pinion to other cars?

The Serpent SER904176 21T is produced for the Viper 988E. It may fit other models if the motor shaft spline, shaft diameter and tooth count match, but always verify measurements before swapping parts.

How should I set the gear mesh?

Place the spur and pinion in mesh, then adjust until there is a slight clearance between teeth when rotated. Tighten the pinion to the motor shaft and recheck with the car running slowly to confirm proper engagement.

When is it time to replace the pinion?

Inspect the teeth for wear, chipping or deformation after regular running. Replace the pinion if teeth show damage or if you notice noisy operation or slippage under load.

Copyright © 2008-2025 rcjaz.ca All rights reserved