Serpent SER804436 Natrix 750 Belt Tensioner Set  [SER804436]

Serpent SER804436 Belt Tensioner set 1/10
Price:
CAD$41.53
Brand:
Serpent
Model:
SER804436
Condition:
Brand New
Write a review

Fine Tune the Natrix 750 Drivetrain with Serpent SER804436

The Serpent SER804436 Belt Tensioner is built for the Natrix 750 200mm GP car to keep drive belts at the correct tension. It helps maintain steady power transfer while lowering belt and pulley wear during track sessions and practice runs.

Fitment and Performance

Made to match the Natrix 750 chassis, the Serpent SER804436 Belt Tensioner holds belt tension steady to reduce slippage and deliver predictable throttle response. Consistent tension improves acceleration feel and contributes to smoother handling on asphalt.

Quick Installation Advice

Fitting the Serpent belt tensioner is a straightforward upgrade for most hobbyists. Align components carefully, fasten hardware to the correct tightness, and recheck belt tracking after the first run. Routine inspections will extend the life of belts and pulleys.

Will the Serpent SER804436 fit models other than the Natrix 750?

This tensioner is designed specifically for the Natrix 750 200mm GP car. While it may physically fit some similar chassis, compatibility is not guaranteed unless the mounting points and belt path match.

How often should I check belt tension on my Natrix 750?

Check belt tension before each race or after several practice runs. Quick inspections catch stretch or misalignment early and help avoid drivetrain damage.

Do I need special tools to install the tensioner?

No specialised tools are required beyond standard RC hex drivers and a small spanner. A torque driver is useful to ensure mounting screws are tightened to a consistent setting.

Copyright © 2008-2025 rcjaz.ca All rights reserved