Serpent SER804411 Rear Left and Right Bearingblock for Natrix 750 Replacement  [SER804411]

Serpent SER804411 Bearingblock up Rear Left + Right S750
Price:
CAD$86.81
Brand:
Serpent
Model:
SER804411
Condition:
Brand New
Write a review

Serpent SER804411 Rear Bearingblock for Natrix 750

The Serpent SER804411 bearingblock is a key rear component for the Natrix 750 that helps maintain stable wheel alignment and solid rear assembly support. It fits the rear left and right positions and is intended to restore correct geometry in club and track use.

Fitment and installation tips

This unit is made to match Natrix 750 mounting points, so fitting is generally straightforward. Use common RC hand tools to swap the parts and verify alignment during reassembly to avoid premature wear.

Accuracy and serviceability

The SER804411 helps reduce slop in the rear end, keeping handling predictable. Inspect the bearingblock and surrounding mounts periodically to ensure consistent performance.

Will this bearingblock fit older Natrix variants?

This bearingblock is produced for the Natrix 750 layout. Older or different Natrix versions may use different mounts, so check the part fit dimensions before ordering.

What do I need to install the SER804411?

Basic RC tools such as hex drivers, screwdrivers and a small spanner are usually enough. Clean the area and follow the chassis setup steps to keep alignment accurate.

How often should I check the rear bearingblocks?

Inspect bearingblocks during routine maintenance or after hard impacts. Look for play or visible wear and replace if the rear feel becomes loose or inconsistent.

Copyright © 2008-2025 rcjaz.ca All rights reserved