Serpent 804344 2.2mm Rear Antiroll Bar for 748 Chassis - Track Tuning  [SER804344]

Dial In Your 748 with a 2.2mm Rear Antiroll Bar

RC builders wanting sharper response from their Serpent 748 will find this 2.2mm rear antiroll bar an effective tuning piece. It is targeted at drivers who prioritise stability and predictable handling at speed. By limiting rear body roll, the bar helps the car stay balanced through mid and high speed corners.

Built for Racing Balance

Made to suit the Serpent 748 chassis, the 2.2mm antiroll bar strikes a measured balance between stiffness and compliance. That balance delivers more consistent traction and allows more confident steering inputs without sacrificing pace.

Fitting and Setup Notes

Ensure mounting points and linkages are tight and correctly aligned during installation to avoid unwanted play. Small setup changes at the rear bar will noticeably alter corner entry and exit, so adjust incrementally and recheck after each run.