Serpent 804195 -1mm Wheel Hex Set - Precision Fit Hexes [SER804195]

Serpent SER804195 Wheel Hexagon -1mm (4)

Price:

CAD$38.10

Brand:

Serpent

Model:

SER804195

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Precision-fit wheel hexes for sharper handling

The Serpent 804195 -1mm Wheel Hex Set is a precision accessory aimed at RC drivers who want to fine-tune wheel position and handling. This four-piece kit delivers a snug connection to reduce slop and keep wheel alignment consistent during aggressive driving.

Highlights of the Serpent wheel hex kit

Precision Engineering: Each hex is produced to close tolerances to reduce play and improve straight-line stability at speed.
Enhanced Tuning: The -1mm offset gives a subtle track width reduction for crisper turn-in and improved mid-corner balance.
Durability: Built to endure frequent track sessions and resist wear under load.
Compatibility: Fits a wide selection of RC car hub setups; verify fit with your model for best results.

How does the -1mm offset change handling?

Reducing track width by 1mm tightens corner entry and can reduce understeer on tighter layouts, helping the car rotate more predictably through bends.

Will these hexes fit my wheel hubs?

They are designed for common RC car hub patterns, but you should measure your hub diameter and spline before fitting to ensure a correct match.

Any tips for installation and setup?

Clean mating surfaces, fit wheels snugly, and check wheel runout after installation. Recheck wheel nut torque after a short test run to confirm stability.