Serpent 601194 - SRX8 RTR Rear Suspension Bracket Race-Ready Replacement  [SER601194]

Serpent SER601194 Suspension Bracket Rear Rear SRX8 RTR
Price:
CAD$6.33
Brand:
Serpent
Model:
SER601194
Condition:
Brand New
Write a review

Upgrade the Rear End of Your SRX8 RTR

The Serpent 601194 rear suspension bracket is a direct replacement designed to help fine-tune the rear geometry of SRX8 RTR builds. Made to suit the Cobra SRX8 Buggy and Truggy line, this bracket focuses on added toughness and consistent handling across rough tracks. Its sturdy construction aims to reduce flex and keep the rear suspension tracking true during hard runs.

Built for Strength and Consistency

Engineered with precision, the Serpent 601194 rear suspension bracket improves durability while maintaining predictable response. It is a practical upgrade for those who compete regularly or push their SRX8 hard off-road. Swapping in this part helps preserve setup settings and keeps the vehicle performing under stress.

Fitment and Simple Installation

This bracket fits Cobra SRX8 Buggy and Truggy EP RTR models and installs with standard RC tools. The straightforward replacement process lets you get back on the track quickly while benefiting from improved rear stability and tuning accuracy.

Will this bracket fit older SRX8 RTR kits?

Verify your SRX8 is an RTR Cobra Buggy or Truggy EP model; this bracket is made for those SRX8 RTR variants and may not match earlier non-RTR chassis without checking mount points.

Do I need any special fasteners to install it?

Installation typically uses the same screws and hardware as the original part, so standard RC hex drivers and pliers will be sufficient in most cases.

Will this change my ride characteristics?

The bracket is intended to increase rear stability and reduce unwanted flex, which can make handling feel firmer and more consistent, especially on rough surfaces.

Copyright © 2008-2025 rcjaz.ca All rights reserved