Serpent 601038 - SRX8 GT High/Low Aluminum Pinion Mount Race Upgrade  [SER601038]

Serpent SER601038 Pinion Mount Aluminium H/L SRX8 GT
Price:
CAD$52.66
Brand:
Serpent
Model:
SER601038
Condition:
Brand New
Write a review

Upgrade SRX8 GT Drivetrain with Serpent 601038

The Serpent 601038 High/Low Aluminum Pinion Mount brings a precision-machined aluminium solution to the SRX8 GT chassis, improving durability and allowing more accurate gear alignment. This component is aimed at racers who want consistent drivetrain performance and reduced maintenance between events.

Built Tough for Track Use

Made from durable aluminium, this pinion mount resists deformation under heavy loads and keeps its geometry through rough race conditions. The material choice helps preserve gear life and keeps performance predictable during long race days.

Fine-Tune Gear Mesh and Handling

The high/low adjustment lets you dial in the pinion position to match different spur gears and track surfaces. That flexibility helps reduce gear lash and vibration, so you can focus on lap times rather than drivetrain issues.

Will this mount fit older SRX8 GT builds?

This part is made for the SRX8 GT platform; many older or slightly different chassis layouts may accept it but check gear shaft diameter and mounting points before assuming compatibility.

How should I set initial gear mesh with this mount?

Start with a small toe-in on the pinion and spin the drivetrain by hand, then adjust until you get a slight contact pattern on the spur gear teeth. Recheck after a few test runs and tighten mounting hardware to spec.

Does aluminium affect motor temperature or noise?

Aluminium is stiffer than plastic mounts so you may notice less vibration and a clearer gear whine. It has minimal effect on motor temperature but improved alignment can reduce load and heat in the drivetrain.

Copyright © 2008-2025 rcjaz.ca All rights reserved