Serpent 600968 Front Antiroll Bar 2.8 mm Track Tuning  [SER600968]

Serpent SER600968 Antiroll bar Front 2.8 mm
Price:
CAD$7.63
Brand:
Serpent
Model:
SER600968
Condition:
Brand New
Write a review

Fine-tune Cornering Balance with Serpent 600968 2.8 mm Front Antiroll Bar

For RC racers chasing consistent lap times, the Serpent 600968 Front Antiroll Bar is a targeted upgrade to improve front-end stability. The 2.8 mm bar helps control body roll so your car stays balanced through mid and high-speed corners.

Performance Gains Without Compromise

Manufactured for strength and repeatable response, this front antiroll bar offers a measured blend of stiffness and compliance. The 2.8 mm diameter gives predictable handling changes so you can tweak setup without losing grip.

Simple Installation and Broad Fitment

The Serpent 600968 fits into many common 1/10 scale chassis and mounts using standard hardware. Installation is straightforward, making it a practical choice for racers who need quick handling adjustments between sessions.

Which cars accept this 2.8 mm front antiroll bar?

It is compatible with the majority of 1/10 scale touring and racing chassis that allow a 2.8 mm front antiroll bar. Check your chassis mounting points for clearance before fitting.

How should I change handling when I fit this bar?

Start with small increments: swap from a softer bar to the 2.8 mm and test one corner at a time. Expect reduced body roll and a firmer front end; adjust rear roll stiffness or shock settings to rebalance if needed.

Any maintenance tips for longevity?

Keep mounting points clean and inspect for wear after heavy sessions. Replace end links or bushings if they show play, and wipe the bar to remove grit that can accelerate wear.

Copyright © 2008-2025 rcjaz.ca All rights reserved