Serpent 600714 Front Suspension Bracket for 811GT - Track Upgrade  [SER600714]

Serpent SER600714 Suspension Bracket Front Front 811GT
Price:
CAD$46.52
Brand:
Serpent
Model:
SER600714
Condition:
Brand New
Write a review

811GT Front End Upgrade with Serpent 600714

The Serpent 600714 Front Suspension Bracket is made specifically for the 811GT to deliver a tough, precision fit that helps maintain alignment under load. Built for durability, this bracket suits racers and hobbyists who need a reliable replacement or upgrade for frequent track use.

Built for Stability and Control

Developed by Serpent with attention to geometry and strength, this bracket improves front-end stability and handling without complex modifications. Its construction is intended to handle the stresses of competitive running while keeping predictable performance.

Specifications

  • Compatibility: Specifically made for 811GT
  • Material: High-strength composite
  • Function: Adds reinforced suspension support

Suitable for serious racers and weekend drivers alike, the Serpent 600714 bracket tightens up the 811GT front end and makes setup more consistent across sessions.

Will this bracket fit aftermarket suspension arms?

The bracket is designed around 811GT mounting points. Some aftermarket arms may fit but you should verify hole spacing and clearances before assuming direct compatibility.

How do I maintain the composite bracket?

Keep the part clean of grit and inspect it after heavy impacts. Avoid harsh solvents, and replace the bracket if you spot cracks or significant wear.

Is special tooling required for installation?

Installation generally needs basic RC tools and the correct hardware. Reuse factory screws if they are in good condition and check alignment and fastener torque after the first few runs.

Copyright © 2008-2025 rcjaz.ca All rights reserved