Serpent 600694 1/8 C-Hub 0 Degree Aluminum Set for Cobra GT/GTe  [SER600694]

Serpent SER600694 C-hub 0 deg Left + Right Aluminium
Price:
CAD$124.45
Brand:
Serpent
Model:
SER600694
Condition:
Brand New
Write a review

Upgrade steering response on your Cobra GT and GTe with Serpent 600694 0-degree C-hubs

The Serpent 600694 C-Hub 0 Degree Aluminum Set is built for the 1/8 Cobra GT and Cobra GTe 4WD GT cars. These parts replace the stock composite hubs and are CNC machined from 7075 T6 aluminum to deliver long-lasting strength and consistent performance. The black anodized finish helps resist wear while keeping a tidy appearance.

CNC Precision for crisper steering feel

These 0-degree C-hubs are engineered to tighten steering feedback and improve stability under load. The 7075 T6 aluminum construction is a notable step up from composite components, giving racers and experienced hobbyists a rugged part that holds geometry lap after lap.

Simple swap-in replacement

As a direct-fit upgrade, installation requires no trimming or special adapters. These C-hubs are made to fit the Cobra GT and Cobra GTe platforms exactly, so you can swap them in quickly and get back to tuning and driving.

Will these C-hubs work with standard Cobra GT steering knuckles?

Yes. The Serpent 600694 hubs are designed as direct replacements for the Cobra GT and Cobra GTe knuckle assemblies and use the same mounting points as the original parts.

Do I need different hardware to install the aluminum C-hubs?

In most cases the original mounting screws and bearings can be reused. Check fastener torque and thread engagement after installation and replace any damaged hardware as needed.

How should I maintain these hubs to prevent wear?

Keep mating surfaces clean and inspect for play after hard runs. Light lubrication on pivot points and routine checks of bearing fit will extend service life.

Copyright © 2008-2025 rcjaz.ca All rights reserved