Serpent 600510 - Rear Centre Driveshaft Upgrade for 811 V3  [SER600510]

Serpent SER600510 Driveshaft Center Rear 811 V3
Price:
CAD$31.66
Brand:
Serpent
Model:
SER600510
Condition:
Brand New
Write a review

Rear driveshaft upgrade for improved drivetrain

Fit the Serpent 600510 into your Serpent 811 V3 to tighten drivetrain engagement and reduce lash in the centreline. This precision rear centre driveshaft is made to deliver steady power transfer and better longevity for regular club runs and practice sessions.

Built for rugged use

The Serpent 600510 rear centre driveshaft is produced to handle typical racing stresses and maintenance cycles. Durable construction helps it stand up to repeated starts, hard landings and intense throttle changes without sacrificing smooth operation.

Straightforward fitment for 811 V3

Made specifically for the Serpent 811 V3 chassis, the driveshaft installs with minimal fuss and aligns cleanly with the factory drivetrain layout. It serves as a direct replacement or an upgrade part when you want consistent on-track behaviour.

Is the Serpent 600510 compatible with other Serpent kits?

This part is optimised for the 811 V3 platform. Other Serpent models may require adaptations or different length driveshafts, so check fitment before installing.

Any tips for installation on the 811 V3?

Use a clean work area, lightly grease splines where appropriate, and confirm the shaft rotates freely without binding before final assembly. A torque-check on related screws is recommended.

How should I maintain the driveshaft?

Inspect for wear at spline interfaces after every few runs, keep mating parts clean, and replace if you see play or scoring. Regular checks extend component life.

Copyright © 2008-2025 rcjaz.ca All rights reserved