Serpent 600407 Front Spring Set Yellow 5.8 lbs - Track Tuning  [SER600407]

Serpent SER600407 Spring set Front Yellow 5.8 lbs (2)
Price:
CAD$10.17
Brand:
Serpent
Model:
SER600407
Condition:
Brand New
Write a review

Fine Suspension Tuning with Serpent 600407 Yellow Springs

If you want to dial in your RC car's front end, the Serpent 600407 Front Spring Set in yellow gives a clear handling upgrade. Rated at 5.8 lbs, these springs help reduce body roll while keeping predictable feedback through corners, making them a practical choice for club and club-level race setups.

Improve Stability and Corner Response

The Serpent 600407 springs are engineered to balance firmness and compliance so you can tune for different track surfaces. Their 5.8 lb rate helps stabilise the chassis under braking and turn-in, which translates to more consistent lap times and easier setup changes.

Fits Multiple Serpent Chassis and Easy Swap

This front spring set works with a wide selection of Serpent chassis and is simple to install during routine maintenance. Swapping to these springs is quick, so you can test setup changes trackside without complex tools or lengthy rebuilds.

They fit many Serpent touring car front assemblies but double check your chassis part list to confirm spring dimensions and fitment before buying.
Start with your stock ride height and make small increments; firmer springs often need slightly lower preload or small spacer changes to retain intended geometry.
Installation usually only requires the standard shock tools and possibly different spring spacers depending on your shock build; no special parts are typically required.

Copyright © 2008-2025 rcjaz.ca All rights reserved