Serpent 600315 Performance 2.5mm Antiroll Bar Wire Set  [SER600315]

Serpent SER600315 Antiroll bar Wire 2.5mm (2)
Price:
CAD$8.97
Brand:
Serpent
Model:
SER600315
Condition:
Brand New
Write a review

Refine Cornering with Serpent 600315 2.5mm Antiroll Wire

For those looking to refine their RC car's handling, the Serpent 600315 Antiroll Bar Wire is a practical upgrade. Designed to tune balance and cornering performance, this 2.5mm wire set helps reduce excessive roll during fast transitions.

How the 2.5mm Diameter Changes Roll Behavior

The 2.5mm gauge gives a controlled increase in stiffness that limits body roll while retaining some compliance for traction. Made by Serpent, this wire is built to last under typical racing and club use.

Quick Fit for Frequent Tuning

Suited for upgrades or replacing tired components, the Serpent 600315 installs easily and lets enthusiasts fine tune front and rear roll characteristics during setup sessions.

It can be used on other makes if their mounting points and clearance match. Measure link spacing and droop before fitting to avoid binding.
Change one end at a time and test on a few laps. Small adjustments to bar length and end position give noticeable changes to understeer and oversteer.
Keep the wire free of grit and inspect bends for fatigue. Replace if there are sharp kinks or signs of metal fatigue to maintain consistent handling.

Copyright © 2008-2025 rcjaz.ca All rights reserved