Serpent 500863 DJC Couplar Performance Upgrade for Spyder SRX4 Gen3  [SER500863]

Price:
CAD$28.76
Brand:
Serpent
Model:
SER500863
Condition:
Brand New
Write a review

Track-Focused Upgrade for Spyder SRX4 Gen3

If you want a dependable replacement for your Spyder SRX4 Gen3 driveline, the Serpent 500863 DJC Couplar delivers a precise fit and solid on-track behaviour. Made to match the Spyder geometry, it helps reduce slop and keeps power transfer consistent.

Machined Durability and Smooth Engagement

The Serpent DJC couplar is manufactured to tight tolerances to provide long-lasting service and consistent engagement. Built to handle intense use, it helps maintain predictable handling during race days and practice sessions.

Fitment Details and Simple Installation

This DJC couplar is created specifically for the Serpent Spyder SRX4 Gen3 EP, so fitting it into an existing car is straightforward. With good alignment and the correct tools, installation is quick and restores drivetrain feel.

Will the DJC couplar work on older Spyder SRX4 versions?

The DJC couplar is tuned for the Serpent Spyder SRX4 Gen3 EP. It may not fit earlier SRX4 variants without modification, so check dimensions before attempting to swap it onto a different generation.

What basic tools are needed to fit the couplar?

Installation normally requires standard RC hand tools such as hex drivers, pliers and thread locker for fasteners. Work on a clean bench and follow standard torque practices to avoid distortion.

How should I maintain the DJC couplar for longevity?

Inspect the couplar for play and wear after hard runs, keep mating surfaces free of grit and replace if excessive movement appears. Routine checks during race weekends help prevent unexpected failures.

Copyright © 2008-2025 rcjaz.ca All rights reserved