Serpent 500800 Front Steel Pivot Pin Brace for SRX2 Gen3 - Race-Ready Reinforcement  [SER500800]

Serpent SER500800 Pivot pin Brace Front Steel SRX2 Gen3
Price:
CAD$12.54
Brand:
Serpent
Model:
SER500800
Condition:
Brand New
Write a review

Steel Precision Upgrade for SRX2 Gen3

The Serpent 500800 Front Steel Pivot Pin Brace is a durable upgrade for SRX2 Gen3 owners, built to improve longevity and keep front suspension alignment stable during hard use. Made from quality steel, this brace helps maintain consistent geometry when pushing on the track.

Benefits of a Steel Pivot Pin Brace

Steel delivers higher wear resistance and long service life compared to softer materials used in some aftermarket parts. Choosing a steel pivot pin brace reduces flex and helps the front end hold its setup through repeated runs.

Designed Around the SRX2 Gen3 Chassis

This part is modelled to fit the SRX2 Gen3 layout precisely, allowing for straightforward installation and minimal setup tweaking. The accurate fit reduces the chance of unwanted play or misalignment after fitting.

Fitting and Alignment Tips

Before fitting the Serpent 500800 Pivot Pin Brace, clean mating surfaces and inspect pins for wear. Fit the brace snugly and re-check toe and camber after installation to confirm handling remains as expected.

Will this fit older SRX2 variants or only Gen3?

The Serpent 500800 is produced for the SRX2 Gen3 chassis geometry; earlier SRX2 versions may not accept the same mounting points without modification.

What basic tools do I need to install it?

A basic hex driver set and a clean workspace are sufficient for most installs. Keep parts free of dirt and use a small brush to clean threads if needed.

Will switching to steel change front-end feel on track?

Steel reduces flex at the pivot points, which can make the front feel firmer. After fitting, verify suspension settings and adjust toe or camber if you notice handling changes.

Copyright © 2008-2025 rcjaz.ca All rights reserved