Serpent 500744 SRX2 Gen3 Rear Antiroll Bar 1.0mm  [SER500744]

Precision Tuning for the SRX2 Gen3 Chassis

The Serpent 500744 Rear Antiroll Bar is made for the SRX2 Gen3 and gives hobbyists a reliable way to refine rear-end behaviour. This 1.0mm bar is a practical option when you need finer control over body roll and mid-corner balance.

Rear Stability and Cornering Balance

Built to reduce unwanted roll and tighten turn-in, this rear antiroll bar improves predictability through fast corners. It helps the SRX2 Gen3 keep a consistent attitude during high speed changes of direction, aiding drivers who tune for lap time and consistency.

Simple Fitment and Chassis Match

The Serpent 500744 installs into the SRX2 Gen3 layout with minimal fuss, fitting the intended mounting points on the chassis. Its design integrates with the Spyder Series components so you can complete the swap without complex modifications.

Key Advantages

• Precision Engineering: Manufactured to refine rear roll and enhance corner control.
• Durable Construction: Made to tolerate regular track use and handling demands.
• Easy Integration: Direct fit to the SRX2 Gen3 for straightforward installation.