Serpent 500724 SRX2 Gen3 Steering Blocks Race Upgrade  [SER500724]

Serpent SER500724 Steeringblock Left + Right SRX2 Gen3
Price:
CAD$17.07
Brand:
Serpent
Model:
SER500724
Condition:
Brand New
Write a review

Accurate Steering for SRX2 Gen3

The Serpent 500724 Steering Block Set is crafted specifically for the SRX2 Gen3 chassis and includes both left and right steering blocks. These parts are made to give racers predictable steering response while withstanding hard use during club and national race days.

Improved Steering Response and Strength

Built with track performance in mind, the steering blocks sharpen turning precision so drivers can place the car more precisely through corners. The rugged construction helps maintain consistent handling lap after lap.

Fitment and Simple Installation

These steering blocks are designed to slot into the SRX2 Gen3 without major changes to the chassis, making them a straightforward upgrade for hobbyists looking to refine their steering geometry.

Will these fit other SRX2 generations?

No, the Serpent 500724 steering blocks are made for the SRX2 Gen3 and are not guaranteed to fit earlier or later SRX2 variants without modification.

What tools are needed to install these blocks?

Basic RC assembly tools such as hex drivers, pliers and thread locker are typically all you need to fit the steering blocks to the SRX2 Gen3.

Any setup tips after installation?

After fitting, check toe and steering centring, and run a few laps to confirm handling. Small trim or toe adjustments can fine tune turn-in behaviour.

Copyright © 2008-2025 rcjaz.ca All rights reserved