Serpent 500704 Rear Aluminium Suspension Bracket for SRX2 Gen3 - Precision Race Part  [SER500704]

Serpent SER500704 Suspension Bracket Rear-Rear Aluminium SRX2 Gen3
Price:
CAD$46.54
Brand:
Serpent
Model:
SER500704
Condition:
Brand New
3 Reviews
Write a review

Precision Upgrade for SRX2 Gen3 Chassis

The Serpent 500704 Rear Aluminium Suspension Bracket is a focused upgrade for SRX2 Gen3 owners seeking tougher rear-end support. Machined from quality aluminium, this bracket improves longevity and delivers tight, repeatable fitment that helps maintain consistent geometry during high-speed laps.

Built for Track Durability

Made to suit the SRX2 Gen3 layout, this rear-rear bracket combines strength with modest weight to preserve agility. The aluminium construction improves structural integrity at the rear of the car, helping drivers dial in handling and reduce flex under load.

Specifications

  • Material: Aluminium
  • Compatibility: Serpent SRX2 Gen3 Chassis
  • Position: Rear-Rear

Recommended by club racers and seasoned hobbyists, the Serpent 500704 Aluminium Suspension Bracket gives a reliable, high-quality option for tightening rear response and prolonging chassis life.

 

Product Reviews
3 Reviews
rating
Very good received : thanks a lot and hope again with you !
rating
Very good received. Thanks a lot and hope again with you.
rating
Very Quick, very good received my orders. Thanks a lot 👍

Which SRX2 Gen3 models will accept this bracket?

The bracket is made to fit Serpent SRX2 Gen3 rear-rear mount points without modification on stock chassis layouts.

Will switching to aluminium change my handling balance?

Aluminum increases stiffness at the rear, which can sharpen turn-in and reduce unwanted flex; setup tweaks may be needed to restore balance.

Any tips for installation and maintenance?

Use threadlocker on steel fasteners, check alignment after first few runs, and inspect for wear or loosening as part of routine maintenance.

Copyright © 2008-2025 rcjaz.ca All rights reserved