Serpent 500623 SDX Aluminum Rollcenter Spacer  [SER500623]

Serpent SER500623 Rollcenter Spacer SDX
Price:
CAD$45.00
Brand:
Serpent
Model:
SER500623
Condition:
Brand New
Write a review

Fine Rollcenter Adjustment with Serpent 500623

If you want to refine your RC car's handling, the Serpent 500623 Aluminum Rollcenter Spacer is a simple, effective option. Made for the SDX chassis, this 2mm aluminum spacer combines strength with low weight and sits under the differential to shift the roll center accurately.

Dial In Grip and Steering

The spacer stacks neatly, so two pieces give you a 4mm raise for further tuning. Small increases in roll center tend to give added front-end bite and crisper steering, though they can also make the car feel a touch more nervous at the limit.

Installation and Setup Notes

When fitting the Serpent 500623 Rollcenter Spacer, make sure it seats and locks in place. Depending on your plate layout you may need to tweak the rear stiffener or related hardware to keep everything aligned and secure.

Will the 500623 work on non SDX chassis?

This spacer is engineered for the Serpent SDX mounting points. It might be possible to adapt it to other cars, but expect to file or modify plates and confirm clearances first.

What does stacking two spacers do?

Stacking two 2mm spacers gives a 4mm lift to the differential, raising the roll center and usually increasing steering response and traction at the front, while potentially increasing mid-corner sensitivity.

Any tips for a clean install?

Ensure the spacer locks into the diff housing and test drive after any change. Check rear stiffener alignment and re-check gear mesh and driveline clearances after fitting.

Copyright © 2008-2025 rcjaz.ca All rights reserved